Daniel Defense Buttstock Grip Vertical Grip Combo

This combo from Daniel defense features 3 great products. The Daniel Defense adjustable buttstock is constructed of a proprietary blend of glass infused polymers and finished off with soft touch rubber overmolding in strategic points. The buttstock is precision formed for mil-spec receiver extensions to have very little forward or lateral play that is so common in many other buttstocks. The buttstock can be run with one of two included buttpads or without any buttpad at all to custom fit the rifle to whatever gear the operator must wear. The buttpads come in two sizes: a thicker convex shape (0.8”), and a thinner concave shape (0.5”); designed to keep from snagging when shouldering the rifle. The Daniel Defense pistol grip is an improvement to the old standby A2. The grip is designed with ergonomics and controllability in mind. This pistol grip incorporates an oversized trigger guard covering the gap between grip and lower receiver which can wear on the shooters hand and easily accommodates for gloves. Installation is simplified by the fact the integral trigger guard doesn’t require a roll pin so there is a reduced chance of damaging the lower receiver. The Daniel Defense vertical grip includes soft touch rubber overmolding for enhanced grip, wet or dry. Inside the grip is a Dual O-Ring, water tight storage compartment capable of storing small parts or 1 AA battery or 2 CR123 batteries. Buttstock 7 Inches Long 5.5 Inches Tall 1.75 Inches Thick Weight: 0.50 lb For Mil-Spec receiver extension tubes Pistol Grip 4.25 Inches Tall 2 Inches Wide 1.38 Inches Thick Weight: 0.20 lb Installation Screw & End Cap Included Vertical Grip 3.3 Inches Tall 1.58 Inches Wide 1.10 Inches Thick Weight: 0.11 lb Features Buttstock, pistol grip, and vertical grip Ergonomic and controllable Enhanced grip, wet or dry Small part storage vertical grip