Buffalo Bore 380 ACP +P Ammunition 95 Grain FMJ-FN 20 Rounds

IMPORTANT INFORMATION ABOUT THE HEADSTAMP ON THIS BRASS: Due to limited supplies of brass, Buffalo Bore has begun loading +P and +P+ ammunition in brass that may not be indicated as such on the headstamp. Example: 9mm Luger +P+ ammunition may be designated as 9mm Luger +P or simply 9mm Luger on the headstamp. Buffalo Bore loads their ammunition up to maximum SAAMI specifications, which delivers devastating performance on a wide range of game. Please note that this ammunition is not intended for older guns. It is made for modern firearms only, as some of the ammunition could damage older and weaker firearms. This ammunition is new production, non-corrosive, in boxer primed, reloadable brass cases. Owner of Buffalo Bore Tim Sundles on 380 +P Ammunition: The 380 auto inhabits a valuable and useful place in our society, mostly because of the easily concealable, tiny pistols chambered for it. HOWEVER, because of the very limited size of the cartridge, it is plagued with limited power and therefore most of the existing ammo in 380 auto suffers from not being reliable as a man-stopper. We've studied and played with nearly all of the existing available 380 ammo and find it wanting as a reliable means of self defense. This 380 Auto+P ammo will better all American made 380 Auto ammo by 150 fps to 200 fps in all bullet weights we make. This is a serious improvement in this typically anemic cartridge. This 380 auto+P ammo is more powerful than the typical 38SPL ammo made by most American ammo makers and you'll get 7 shots of it in a small/flat/light weight 380 versus 5 shots out of a bulkier 38 SPL J frame revolver. Additionally, with the 380 you'll get much faster reloads and the little magazines are flatter than a speed-loader used for a J frame. Item 27B/20 is the very same load as 27A but, it uses a 95 gr. FMJ-FN (Full metal jacket-flat nose) bullet. We designed it for folks who simply don't like hard cast bullets. Although it is 5 grains lighter, it is moving a tad bit slower than the 100gr. hard cast bullet. This is because the hard cast bullet produces less friction in the barrel than a jacketed bullet and therefore produces less pressure, so we can run it a little faster even though it is heavier. Some pistols may not give good accuracy with the cast bullet, and some folks don't like cast bullets, so we made the same load with a jacketed bullet for those folks. This FMJ-FN load is designed to do the very same thing as the hard cast load above. Check out my "real world" velocities from my "real world" pistols below. 1. BDA-3.75 inch barrel----1145 fps 2. Walther PPK-3.5 inch barrel----1120 fps 3. Colt Mustang Pocket Lite-2.75 inch barrel----1042 fps 4. Keltec - 2.75 inch barrel----1019 fps